Please wait while we process your request.

Acopian Power Supply Model W24LT1880

  Product Price Qty
Acopian Power Supply Model W24LT1880

 

Power Supply Model: W24LT1880 $615.00
   
    Option (suffix "G7") $50.00  
    Alarm with Relay Contacts
Form C alarm contacts (contacts rated at 175v, .5A) that change state when output reaches 10% below or 15% above nominal voltage. This option not available with option "L4". ('V ok' signal is disabled with this option.)
   
    Option (suffix "F") $50.00  
    Moisture/Fungus Proofing
Moisture and fungus resistant varnish applied to interior surfaces. (2 days additional shipping time)
   
    Option (suffix "H5") $15.00  
    15Vdc Auxiliary Voltage
+15Vdc 2% at 100mA. This option is not available with options "N" or "P".
   
    Option (suffix "L4") $115.00  
    208 VAC 3-phase Input Voltage
170-240 VAC 3-phase, 60-400 Hz. This option is not abailable with option "G7".
   
    Option (suffix "E1") $25.00  
    Output Blocking Protection Diode
Used for battery charging or redundant applications. Derate output by 10%.
   
    Option (suffix "D2") $30.00  
    Thermostatically Controlled Fan
Fan runs at reduced speed until maximum speed is required.
   
    Option (suffix "U") $0.00  
    UL 508 Marking
 
   
    Option (suffix "P") $25.00  
    Parallelable
Allows up to 4 like models to be directly wired in parallel for increased current capability. Current share accuracy is 5% (typical). Power supply output current must be derated by 5%.
   
    Option (suffix "N") $50.00  
    N+1 Redundancy
Allows up to 4 like models to be wired in N+1 redundancy. An internal isolation OR-ing diode is included in each power supply. Current share accuracy is 5% (typical). Power supply output current must be derated by 10%.
   
    Option (suffix "E") $0.00  
    Output Enable
To enable the DC output, the Inhibit terminal must be tied to the -DC output. An open collector or contact closure can be used.
   
  Mounting Kit for Wall Mounting $10.00
  NP6 (View drawing of Mounting Kit for Wall Mounting) To mount from the power supply side of the mounting surface, necessary when the other side of the mounting surface is inaccessible, use accessory Mounting Kit NP6. This kit consists of four aluminum brackets and four machine screws for fastening them to the power supply, effectively adding mounting flanges to the power supply.    
  Mounting Kit for DIN Rail Mounting (Vertical mounting) $15.00
  WL35DIN (View drawing of Mounting Kit for DIN Rail Mounting (Vertical mounting)) Threaded mounting holes permit mounting the power supplies to a chassis, cabinet wall or bracket, or they may be used on a test bench or table top.    
  Mounting Kit for DIN Rail Mounting (Horizontal mounting) $15.00
  WLH35DIN (View drawing of Mounting Kit for DIN Rail Mounting (Horizontal mounting)) Threaded mounting holes permit mounting the power supplies to a chassis, cabinet wall or bracket, or they may be used on a test bench or table top.    
Back
If you have a question or problem, or would like to order by phone, please call 1-800-523-9478 (8am-5pm EST M-F)