Made In The USA
Gold Box
Programmable with a Control Voltage or a Potentiometer
(3-Day Power Supply)
Linear Regulated Power Supplies
AC-DC wide adjust output
- Shipped Within 3 Days
- Five Year Warranty
Specifications
Input Voltage: 105-125 VAC, 50-400 Hz, single phase.
Regulation, Ripple:
Line Regulation: ±0.005% or 2 mV, whichever is greater.
Load Regulation: ±0.005% or 2 mV, whichever is greater.
Ripple: 0.25 mV rms.
Remote Voltage Sensing: Provision for sensing the output voltage across the load, to compensate voltage drops in output wiring, is a standard feature.
Controls: Coarse and fine voltage adjustments are located on the front panel.
Output Voltage Programming:
With a Control Voltage: The output voltage may be programmed from 0 to full rating by means of control voltage inputs of 0 to +10Vdc. Linearity, 1%.
Contact factory for information on other input ranges.
With a Potentiometer: The output voltage may be programmed by means of a remotely located 5K potentiometer.
Current Limiting: Rolloff characteristic with automatic recovery.
Polarity: Output is floating; either positive or negative terminal may be grounded or floated up to 300 volts above ground. When using a control voltage input, its negative side must be connected to the –S (sense) terminal.
Temperature Coefficient: 0.02%/°C (Typical).
Ambient Operating Temperature: –20 to +71°C.
Storage Temperature: –55 to +85°C.
Size and Weight:
Case | Rough | Approx. Size | Dimensions (inches) | weight -------|---------------------|-------------- M6 3.4 x 5.1 x 7.2 5 lb. 10 oz. -------------------------------------------- M9 3.4 x 5.1 x 9.8 6 lb. 7 oz. -------------------------------------------- M13 3.4 x 5.1 x 13.8 8 lb. 8 oz. -------------------------------------------- H11 5.1 x 7.4 x 12.0 13 lb. 3 oz. -------------------------------------------- H16 5.1 x 7.4 x 16.8 18 lb. -------------------------------------------- See Drawing for exact dimensions.
Mounting: Threaded mounting holes permit mounting to a chassis, cabinet wall or bracket, or they may be used on a test bench or tabletop. To mount from the power supply side of the mounting surface, use accessory Mounting Kit GB8 (see Accesssory Mounting Kits). To mount on a DIN rail, see Accesssory Mounting Kits.