Rack Mounting
Programmable with a Control Voltage or a Potentiometer (9-Day Power Supply)
Linear Regulated Power Supplies

AC-DC wide adjust output


Input Voltage: 105-125 VAC, 50-400 Hz, single phase.

Regulation, Ripple:
Line Regulation: ±0.005% or 2 mV, whichever is greater.
Load Regulation: ±0.005% or 2 mV, whichever is greater.
Ripple: 0.25 mV rms.

Remote Voltage Sensing: Provision for sensing the output voltage across the load, to compensate voltage drops in output wiring, is a standard feature.

Controls: Coarse and fine voltage adjustments are located on the rear panel.

Output Voltage Programming:

With a Control Voltage: The output voltage may be programmed from 0 to full rating by means of control voltage inputs of 0 to +10Vdc. Linearity, 1%.
Contact factory for information on other input ranges.
With a Potentiometer: The output voltage may be programmed by means of a remotely located 5K potentiometer.

Current Limiting: Rolloff characteristic with automatic recovery.

Polarity: Output is floating; either positive or negative terminal may be grounded or floated up to 300 volts above ground. When using a control voltage input, its negative side must be connected to the –S (sense) terminal.

Temperature Coefficient: 0.02%/°C (Typical).

Ambient Operating Temperature: –20 to +71°C.

Storage Temperature: –55 to +85°C.

Size and Weight:

Case   | Rough                        |  Approx. 
Size   | Dimensions (inches)          |  weight 
3P11     3.5 x 19" panel, 11.0" deep      16 lb.
3P17     3.5 x 19" panel, 16.9" deep      26 lb.
5P12     5.3 x 19" panel, 12.1" deep      20 lb.
5P17     5.3 x 19" panel, 16.9" deep      30 lb.

Front Panel Finish: Light gray baked enamel.